![]() ![]() It’s up to you how long to make the notches in the ends of the timber.This joint looks like you just have 1 piece of timber since they are joined flushly.This is a good option when you have 2 lengths of timber that you want to join into an almost seamless single length of timber, since the joint isn’t very noticeable.Apply wood glue to the notches, fit the 2 pieces of timber together like a puzzle, and clamp them tightly until the glue dries. Cut matching notches that are half as deep as the thickness of the timber and the same length as each other into the ends of your 2 pieces of timber using a table saw or a circular saw. Never just bolt beams to the side of a post without cutting a notch into it because the downward pressure of any weight on top can cause them to shear off.Ĭonnect them using a half lap joint.The end result of this is that the beams sit flush with the side and the top of the post.This is a good option when you don’t have any commercial hardware available or you want the beams to be at exactly the same height as the post.For example, if you’re using 6 in (15 cm) by 6 in (15 cm) beams, make a notch that’s 6 in (15 cm) tall and 3 in (7.6 cm) deep.Tighten the nuts all the way with a wrench. Slide a 0.5 in (1.3 cm) diameter carriage bolt with a washer on it through each hole and put a washer and a nut on the end of each bolt. Set the 2 beams into the notch, next to one another, and drill two 0.5 in (1.3 cm) wide holes, to the left and right of the center of the beams and offset diagonally from one another, through the beams and the post. Cut a notch into the top of the post using a circular saw that matches the height of the beams and that is as deep as the combined thickness of the 2 beams. Bolt the beams into a notch at the top of the post.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |